SerVision CVG-M Información técnica descargar pdf (Pagina 49)

SerVision Embedded Video Gateway System Guide

Configuring System Settings 48

NOTE: Unless you have made other changes to the configuration that require a system restart, it is not

necessary to restart the system after the WiFi settings are saved.



To configure an access point:

1. In the Main Menu, under System, click WiFi. The WiFi Configuration screen opens. (This may take a

minute or two.)

Figure 48: WiFi Configuration screen

2. If you will be configuring more than one SSID, under Random Selection of SSID, do one of the following:

 Select Enabled if you want the unit to remain connected to the current access point as long as it can, even

if an access point with a higher priority level becomes available.

 Clear Enabled if you want the unit to disconnect from lower-priority access points when higher-priority

access points become available.

3. Under Configured SSIDs, fill in the required information for each access point to which you want the unit to

be able to connect, as described in steps 4–8 below.

4. Under SSID, fill in the SSID of the access point.

Note: If a wireless card is connected to the unit, access points that are detected within range of the unit are

listed under SSIDs in Range at the bottom of the screen. Click Add SSID to add a detected SSID to the list of

configured SSIDs. (If a detected access point is in the list of configured SSIDs, it does not appear in the list of

detected access points.)

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 202 203

Sin comentarios

SerVision CVG-M Información técnica Pagina 49