SerVision CVG-M Información técnica descargar pdf (Pagina 124)

SerVision Embedded Video Gateway System Guide

Defining Alternate Outlines 123

Note: If a device is not enabled in the Default outline, it cannot be enabled in any other outline. In this case,

the configuration screen of the device in the outline section will say the device is disabled (see figure 139). For

information about activating a device in the Default outline, see page 111.

Figure 139: Device that is not enabled in the Default outline

7. Select the desired settings for the device in the current outline.

Note: For information about the settings, please refer to the section of this manual that relates to each type of

setting, as follows:



Video Motion Detection (VMD), page 88

Note: If VMD is enabled for a camera in the default outline, it cannot be disabled in any other outline.

Similarly, VMD regions can only be defined and modified in the default outline; they are applied in all

outlines in accordance with their definitions in the default outline.



Configuring Video Lost, page 94



Video Recording Settings, page 96



Configuring Sensor and Activator Settings, page 110

Note: In the Camera screens, when recording is by event, the sensors and activators can only be selected

as triggers if they are already enabled in the current outline. Thus, for example, if you want to select

Sensor 1 as a trigger for the Camera 1 recorder, you must first enable Sensor 1 in its configuration screen,

and then select it in the Camera 1 configuration screen.

8. Click Update.

9. Repeat steps 6–8 for each of the cameras, sensors, and activators connected to the Video Gateway.

10. Save the changes. The settings will be implemented after the unit is restarted (see Saving Configuration

Changes, page 125).

Activating Outlines Manually

If more than one outline is defined, and outline switching is not performed automatically by the system (by means

of Sensor 1 or through a schedule), you can manually select the outline you want to run at any time. In addition, you

can specify that the selected outline be loaded automatically when the unit first starts up. In this case, the selected

outline replaces the Default outline as the system default.

1 2 ... 119 120 121 122 123 124 125 126 127 128 129 ... 202 203

Sin comentarios

SerVision CVG-M Información técnica Pagina 124