SerVision CVG-M Información técnica descargar pdf (Pagina 28)

SerVision Embedded Video Gateway System Guide

Configuring System Settings 27

NOTE: SerVision does not provide any software for handling NMEA data that is transmitted to an NMEA

server. You must acquire and set up any required software on your own.



To configure the GPS settings:

1. In the General System Settings screen, under GPS, select Enabled. The fields required to configure the

GPS settings are added to the screen:

Figure 22: GPS settings

2. Fill in the fields as follows:

Field

Description

GPS Frequency

Specify how often the unit records its location, in seconds. Recommended value: 5.

Note: Because GPS location recording requires system resources, it is not recommended

to increase the frequency. While one check every five seconds is not sufficient for

navigation via GPS, it provides ample information for tracking purposes.

GPS Recording

Select this option to record the results of each GPS location check. This option must be

selected it you want to be able to see the route followed by the vehicle, or see where the

vehicle was when a particular event occurred, in the MultiClient.

Note: Clearing this option does not free disk space for other uses.

3. If you want to send NMEA data to a server or a device connected to the serial port, under NMEA, select

Enabled. The fields required to configure this option are added to the screen.

Figure 23: NMEA server settings

Note: Whenever NMEA is enabled, GPS recording is automatically activated and cannot be deactivated.

4. Fill in the fields as follows:

Field

Description

RMC to server

Select this option if you want to send GPS data in RMC syntax to an NMEA server.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 202 203

Sin comentarios

SerVision CVG-M Información técnica Pagina 28