SerVision CVG-M Información técnica Pagina 165

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 203
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 164
SerVision Embedded Video Gateway System Guide
Restoring Factory Settings 164
Figure 192: Jumper connected to pins 2 and 3
4. Reconnect the power to the unit. When the startup process is completed (the Power LED on the front of the
unit flashes at frequent intervals), the default factory settings are restored.
5. Disconnect the power from the unit again.
6. Remove the jumper from the RS232/485 connector.
7. If you disconnected a PTZ controller before performing this procedure, reconnect the controller.
8. Reconnect the power to the unit.
Vista de pagina 164
1 2 ... 160 161 162 163 164 165 166 167 168 169 170 ... 202 203

Comentarios a estos manuales

Sin comentarios