SerVision CVG-M Información técnica descargar pdf (Pagina 31)

SerVision Embedded Video Gateway System Guide

Configuring System Settings 30

Note: TV-Out cannot be enabled if recording framerates are very high (see Advanced Recorder Settings,

page 97). In this case, if you attempt to enable TV-Out, a TV-Out Disabled message will be displayed:

Figure 27: TV-Out Disabled message

3. Fill in the fields as follows:

Field

Description

Display type

Select the desired layout for the video display on the monitor:

 Split Screen: Divides the screen so that video from all the

cameras is visible all the time

 Full Screen – Camera #: Displays video from the specified

camera in full-screen mode

 Full Screen – Rotate: Loops through all of the cameras,

displaying each in full-screen mode for the number of seconds

specified under Rotate delay

Rotate delay

If you selected the Full Screen – Rotate display type, specify the number of

seconds you want the video from each camera to be displayed before it is replaced

with video from the next camera.

Note: This field only appears if the Full Screen – Rotate display type is selected.

Display Switch Via

Sensor

Select this option if a switch is connected to the relevant sensor connector on the

unit (In6 on the HVG; In4 on the MVG, and UVG; In1 on CVG and CVG-M models),

and you want to use the switch to cycle through the various display types.

Note: This option is only fully activated if it is selected here and configured in the

appropriate sensor configuration screen (for HVG, MVG, or UVG, the Sensor 4

configuration screen; for CVG or CVG-M, the Sensor configuration screen), as

described under

Configuring a Sensor to Control CCTV Display

, page 116.

Note: On CVG and CVG-M models, this option should not be selected if the sensor

connector (In1) is used for an outline switch. For additional information, please refer

to the unit’s installation guide.

Cameras

Select the cameras that will be accessible via the monitor. Cameras that are not

selected do not appear in the monitor at all. Video from these cameras cannot be

viewed on the monitor and the cameras cannot be configured through the monitor.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 202 203

Sin comentarios

SerVision CVG-M Información técnica Pagina 31