SerVision CVG-M Guía de instalación descargar pdf (Pagina 33)

SerVision CVG-M Installation Guide

Connecting the CVG-M to a Power Source 32

Figure 32: Wire connector

Figure 33: Wire connector plugged into Power connector

2. Using 16 AWG red cable, connect the unit to the vehicle battery as follows:

•

Connect one end of the red wire to the positive (+) connector of the Power wire connector (the middle

connector in the block).

•

Connect the other end of the red wire to the positive (+) connector of the vehicle battery or power source

3. Using 16 AWG black cable, connect the unit to the vehicle battery as follows:

•

Connect one end of the black wire to the negative (-) connector of the Power wire connector (the right

connector in the block).

•

Connect the other end of the black wire to the negative (-) connector of the vehicle battery or power

source

4. If you need to connect the unit to the ignition, using 16 AWG black cable, connect the IGN connector to the

ignition, as illustrated in figure 34. If you do not need to connect the unit to the ignition, using 16 AWG black

cable, connect the IGN connector to the positive (+) connector of the Power wire connector (the middle

connector in the block), as illustrated in figure 35.

Figure 34: Connecting the CVG-M to the vehicle battery and the ignition

(

) connector

(-) connector

IGN

connector

Connect to negative (

)

battery connector

Connect to positive (+)

battery connector

Connect to

the ignition

1 2 ... 28 29 30 31 32 33 34 35 36 37 38

Sin comentarios

SerVision CVG-M Guía de instalación Pagina 33