SerVision CVG-M Guía de instalación descargar pdf (Pagina 30)

SerVision CVG-M Installation Guide

Connecting the CVG-M to a Power Source 29

Connecting the CVG-M to a Power Source

The CVG-M can be connected either to an electrical outlet using the supplied power-supply cable, or to the ignition

of a vehicle, using the supplied power cord.

Once it is connected, the unit starts up automatically. During the start-up process, the Power LED on the top of the

unit flashes at various intervals. When the start-up process is completed successfully, the Power LED should

display as a solid color and blink momentarily every second. (Depending on the configuration settings, it should

either be solid orange and then blink green or solid green and then blink orange.)

Figure 27: Power LED

NOTE: When the start-up process is completed, if the Power LED does not flash – if it displays as a solid

green or orange all the time – the start-up process was not successful. In this case, disconnect the unit

from the power supply and then reconnect it.

Typically, the CVG-M unit is configured in an office setting and then installed in the vehicle. The power-supply

and power-connector cables are used to connect the unit to a standard electric outlet for configuration. After

configuration, the cables are disconnected from the unit, so that it can be connected to the vehicle battery.

NOTE: It is recommended that only a vehicle installation specialist connect the unit to the battery.

Connecting the Wire Connector to the Unit

Demo units and small orders are supplied without a wire connector in the Power connector on the rear panel of the

unit, as in figure 29. In large orders, the units are supplied with wire-connectors connected to the Power connectors

on the units, as in figure 30 (because only a limited number of power-connector cables are supplied with large

orders, and every unit requires a wire connector).

Figure 28: Wire connector

Power LED

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 36 37 38

Sin comentarios

SerVision CVG-M Guía de instalación Pagina 30