SerVision CVG-M Guía de instalación descargar pdf (Pagina 26)

SerVision CVG-M Installation Guide

Connecting Devices to the CVG-M 25

Figure 23: RS232/485 adapter

4. If the monitor is touch-sensitive, it is recommended that you calibrate it before you use it. For information

about how to calibrate the monitor, please refer to the monitor’s documentation.

Connecting a Switch

If you wish, you can connect a switch to the unit to change the display on the monitor. The switch must be

connected to the In1 connector. For additional information, see Connecting Sensors, page 16, and refer to the

Embedded Video Gateway System Guide.

Connecting Multiple Monitors

If you wish, you can connect multiple CCTV monitors to the CVG-M. For example, you may wish to have one

monitor beside the driver’s seat and another beside the conductor’s seat.

To connect multiple monitors, you must use video splitters to split the connection. Bear in mind, however, that the

image quality in each of the monitors will be slightly degraded. To correct this problem, you can use a video

amplifier (booster) for each monitor. To ensure you have the correct equipment, consult a video equipment supplier.

Plug into RS232/485

connector on CVG-M

RS232 connector

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 37 38

Sin comentarios

SerVision CVG-M Guía de instalación Pagina 26